• THREADED STUD WITH PARTIAL THREAD TYPE PD
  • THREADED STUD WITH PARTIAL THREAD TYPE PD
  • THREADED STUD WITH PARTIAL THREAD TYPE PD
  • THREADED STUD WITH PARTIAL THREAD TYPE PD
Products

THREADED STUD WITH PARTIAL THREAD TYPE PD

DRAWN ARC STUDS WELDING

THREADED STUD WITH PARTIAL THREAD TYPE PD

The PD-type drawn arc welding stud complete with ferrule ceramic is a partially threaded stud with the same mechanical characteristics as the arc-welded MPF type stud, but its thread stops much farther from the welding section.

The PD-type arc welding pin is available with thread starting from M6 up to M24.

Through the use of the drawn arc welding machine, the PD-type arc welding pin is welded in a long arc with a ceramic ferrule or welded in gas protection with appropriate limitations.

The production of the PD type arc-welded stud is carried out using the 4.8 iron, PD stainless A2-50 type threaded arch pivot and arc welding stud type PD 1.4571.

Informative

We and selected third parties use cookies or similar technologies for technical purposes and, with your consent, also for other purposes as specified in the .
If you close this banner with a tick or click on "Decline", only technical cookies will be used. If you want to select the cookies to be installed, click on 'Customise'. If you prefer, you can consent to the use of all cookies, including cookies other than technical cookies, by clicking on "Accept all". You can change your choice at any time.