• THREADED STUD TYPE MPF
  • THREADED STUD TYPE MPF
  • THREADED STUD TYPE MPF
  • THREADED STUD TYPE MPF
Products

THREADED STUD TYPE MPF

DRAWN ARC STUDS WELDING

THREADED STUD TYPE MPF

The MPF drawn arc welding stud is threaded almost to the welding tip, the cross-section diameter is the wire size with which the MPF type weld stud is produced, so the weld bead will be about 3-4mm wider of the thread.

The maximum load borne by a MPF type weld pin is the same as any bolt made of material 4.8.

The MPF welding stud complete with ceramic ferrule is available with thread starting from M6 up to M20.

Through the use of the drawn arc welding machine, the arc-welded pin type MPF is welded in a long arc with a ferrule ceramic or welded in gas protection with appropriate limitations.

The production of the MPF arc-welded stud is carried out using the 4.8 iron, MPF pin in stainless steel A2-50 and stud welding type MPF in 1.4571.

Informative

We and selected third parties use cookies or similar technologies for technical purposes and, with your consent, also for other purposes as specified in the .
If you close this banner with a tick or click on "Decline", only technical cookies will be used. If you want to select the cookies to be installed, click on 'Customise'. If you prefer, you can consent to the use of all cookies, including cookies other than technical cookies, by clicking on "Accept all". You can change your choice at any time.